TilingPlastering and renderingFloor levelingFinishingPrimersOther adhesivesWaterproofing and repairingTile GroutsUnmodified mixes
rus  |  eng
 
 

Base preparation

   The surface for plaster application must be solid, cleaned from dust, mud, oil, fats, lime, wax, chalk or lime mixtures, oil or emulsion paints. Prior to plastering, the basis and board joints must be treated with IVSIL OSNOVA primer. 

   Strongly absorbing bases (gaze and foam concrete, gipsum plaster, anhydrite) should be primed with IVSIL GLUBOKOGO PRONIKNOVENIYA (primer penetrator) and pre-aligned by one of repairing plasters IVSIL.

   Unevenness of a walls, a crack, and a recess should be also pre-aligned.

Mixing of mortar

   Dry mix is poured into a mixing bucket with clean water in proportion of 20 kg of dry mix per 6 - 6,5 l of water, then thoroughly stirred manually or with the help of mixing drill for approx. 2 minute, until homogeneous, elastic mixture without any lumps or clots is received. The mixture is left for 5 minutes and then stirred again.

   Prepared mix should be used within 15 - 24 hours.

Application

   Ready mixture is applied on prepared surface with a metal trowel to form a layer of 0,5 to 8 mm. A small steel trowel (30 cm) is used for partial levelling, and a two-handed trowel for whole levelling. 

   If necessary, several layers can be applied, providing every previous layer has already dried. The basis and air temperature should be +5ºC to +30ºC. Dried layer should be polished with a fine abrasive material (sand paper).

 
Consultation on the pplication materials

GREENTEX

  

   White polymer-based IVSIL finish GREENTEX putty for indoor walls and ceilings in dry conditions is based on polymer bonding agent with a set of highly effective additives. Polymer putty for finishing treatment of walls and ceiling made of concrete, plastered surfaces, plasterboards, gypsum-fibre boards is used prior to application of paint or any other decorative cover inside dry premises.

   It is easy to apply, has high level of elasticity, easy to polish. After polishing polymer putty preserve solid structure. It is recommended for use prior to painting.

   Due to its ability to be applied in a thin layer, it is very economical. Having dried it forms a perfectly smooth, even, pure white surface, which is cost effective for further application of paint.

   Pot-life of ready solution from miximg with water is up to 7 days (in a sealed tub), which allows to continue the work without making new mixture every time.

   Basic price of IVSIL polymer finishing plaser is 429 roubled/25kg. To see prices of other IVSIL finishing putties, plasters and stucco, please visit the section Price list. Packages of 5kg and 25kg are available.

   See also: fine gypsum putty IVSIL FINISHNAYA or go back to the section Finishing.

   IVSIL dry finishing plasters: polymer coating IVSIL GREENTEX, white thin finishing polymer putty.

 
 

Technical characteristics

Mixing proportion: 1l of water
On 1 kg of a mix0,22 0,25
On 20 kg of a mix7 7,6
On 25 kg of a mix7,5 - 8,75 l
The consumption at a thickness of a layer of 1 mm, on 1 sq. m0,9 1 kg
Viability of a solution1524 h
Hardening time6
Packaging20 kg
Filling material fraction, not more than0,2 mm
 
 
Home Search and map
Rambler's Top100
Site development —
the Internet-agency «Webstroy»